Publications

Showing 1676 - 1700 of 1918 results
This bulletin has been produced to provide guidance for employers in managing the occupational safety and health of migrant workers.
WorkSafe
Guide / handbook
21 May 2014
Tips for carers on preventing musculoskeletal injuries from performing manual tasks.
WorkSafe
Guide / handbook
21 May 2014
This bulletin has been produced to raise awareness on occupational safety and health issues relevant to older workers. Employers have a general duty of care to address potential age-related factors...
WorkSafe
Guide / handbook
21 May 2014
This fact sheet contains information on preventing and managing psychological health for small businesses in relation to their duty of care under the Occupational Health and Safety Act 198 4.
WorkSafe
Fact sheet
21 May 2014
The purpose of this code of practice is to provide advice on the preparation of Material Safety Data Sheets (MSDS) where required by legislation. The aim is to provide consistent health and safety advice to persons who could be exposed to hazardous substances and Dangerous Goods.
WorkSafe
Code of practice
21 May 2014
This code of practice aims to provide practical guidance for public sector agencies to achieve compliance with the obligations of the Occupational Safety and Health Act 1984 and the Occupational Safety and Health Regulations 1996. This code also promotes the role of occupational safety and health (OSH) management systems and the importance of chief executive officer leadership in improving OSH performance. It acknowledges that an effective OSH management system is a critical component of an agency’s overall risk management program.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to venues, where employees or the self-employed are present, where live (whether amplified or not) or recorded music is being played for entertainment purposes at levels which are likely to exceed the exposure standard for noise.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act 1984 where excessive noise may exist. This code provides practical guidance for the management of noise which may be damaging to the hearing of people in workplaces. The approved code of practice Control of Noise in the Music Entertainment Industry provides additional information on controlling noise in that industry.
WorkSafe
Code of practice
21 May 2014
The purpose of this national code of practice is to provide practical guidance in the identification of health hazards, evaluation of risks and control of exposure associated with the manufacture of vinyl chloride and its subsequent polymerisation to polyvinyl chloride (PVC). Note that vinyl chloride is often referred to as vinyl chloride monomer (VCM).
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act 1984 and provides detailed guidance on the prevention of falls at workplaces.
WorkSafe
Code of practice
21 May 2014
The Ferry and Charter Boat Industry Code of Practice (the Code), provides practical guidance on the safe operation of commercial vessels operating in the ferry and charter boat industry in Western Australia. It is designed to assist those working in the industry to identify, assess and control risks to themselves, colleagues and passengers.
WorkSafe
Code of practice
21 May 2014
This code of practice addresses issues that might potentially arise in some working hours arrangements, for example extended hours, shift work and on call work. It brings together a range of recognised workplace hazard factors that must already be addressed, as far as practicable, where there are occupational safety and health risks. This code of practice is presented as a starting point for undertaking a workplace or industry risk management process to address relevant issues where the working hours arrangements may have occupational safety and health considerations. As individual workplaces and industries have different working hours arrangements, this code of practice provides high level general guidance and recommendations on risk management. It is suggested that the risk management approach is tailored specific to the unique demands of each workplace and/or industry
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act and is intended to assist those involved in designing buildings or other structures to meet the requirements of the Occupational Safety and Health Act 1984 and the Occupational Safety and Health Regulations 1996. In particular, this code of practice aims to: explain the legal obligations applicable to a person who is in control of, or who may have influence over, the design of a building or structure; and provide guidelines for ways in which these obligations can be met by providing practical guidance on ways of maximising the safety of the design.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act. It provides: general guidance for employers and workers on the identification, assessment and control of safety and health hazards and risks associated with manual tasks in which forces exerted, loads handled, repetitive movement, awkward postures, sustained postures and equipment and tools that expose workers to vibration are of concern; and information on key legislative requirements in the OSH act and the OSH regulations, as they relate to hazardous manual tasks.
WorkSafe
Code of practice
21 May 2014
This code applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act 1984 and provides practical guidance for commercial vehicle drivers, and for those who are responsible for the operation of commercial vehicles in workplaces, on carrying out their duties under the Occupational Safety and Health Act 1984 and meeting the requirements of the Occupational Safety and Health Regulations 1996.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act 1984 where concrete and masonry cutting and drilling equipment is used.
WorkSafe
Code of practice
21 May 2014
This code of practice provides practical guidance and strategies to reduce exposure to styrene of persons in the fibreglass reinforced plastics industry. The code is intended to assist in the control of levels of styrene monomer to as low as reasonably practicable below the occupational exposure standard of 50 ppm (TWA)*.
WorkSafe
Code of practice
21 May 2014
This national code of practice has been developed to assist persons with control of premises and/or plant to control the risks of asbestos-containing materials (ACM) in workplaces. It sets out the steps to be taken to eliminate or otherwise minimise the risks of exposure to airborne asbestos fibres, including the identification of ACM, risk assessments and the implementation of control measures. The objective of these measures is to prevent workplace exposure to airborne asbestos fibres and thereby reduce the incidence of asbestos-related diseases such as mesothelioma, asbestosis and lung cancer.
WorkSafe
Code of practice
21 May 2014
The purpose of this National Code of Practice for the Safe Use of Synthetic Mineral Fibres is to provide a safe and healthy workplace by outlining safe work practices and general responsibilities when handling synthetic mineral fibres (SMF).
WorkSafe
Code of practice
21 May 2014
This code applies to all workplaces where spray painting is undertaken, and to all persons with potential for exposure to hazards resulting from spray painting in those workplaces and includes: all areas where paints are sprayed; all areas of a spray painting operation where associated processes such as mixing, pouring and tinting of paints is carried out; all areas of a spray painting operation where spray painting substances,such as paints and solvents, are stored; and some aspects of industrial and marine coatings. This code of practice should be used by all persons involved in any aspect of spray painting, including employers, contractors, employees, safety and health representatives, designers, manufacturers and suppliers of plant or materials used in spray painting.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by either the OSH Act or the MSI Act and provides: general guidance for employers, people in control of workplaces, designers, manufacturers, suppliers and workers on the identification and control of safety and health hazards and risks associated with Legionnaires’ disease; and information on key legislative requirements in the OSH Act, the OSH Regulations, the MSI Act and the MSI Regulations as they relate to Legionnaires’ disease.
WorkSafe
Code of practice
21 May 2014
This code of practice applies to all workplaces in Western Australia covered by the Occupational Safety and Health Act 1984 where excavation occurs, and to all persons with the potential for exposure to hazards resulting from excavation in those workplaces, including: all areas where equipment is used to excavate; and all areas where processes associated with excavation are undertaken.
WorkSafe
Code of practice
21 May 2014
The aim of this National Code of Practice for the Labelling of Workplace Substances [NOHSC:2012(1994)] is to provide practical guidance on meeting the requirements for the labelling of hazardous substances used at work under the National Model Regulations for the Control of workplace hazardous substances [NOHSC:1005(1994)] and the Commonwealth, State and Territory regulations introduced in accordance with these national model regulations.
WorkSafe
Code of practice
21 May 2014
This National Code of Practice for the Control of Workplace Hazardous Substances [NOHSC:2007(1994)] provides a practical guide on how to comply with the National Model Regulations for the Control of Workplace Hazardous Substances [NOHSC:1005(1994)] so as to minimise the risk of disease and injury due to exposure to hazardous substances in the workplace.
WorkSafe
Code of practice
21 May 2014
The purpose of this National Code of Practice for the Control of Scheduled Carcinogenic Substances [NOHSC:2014(1995)] is to provide practical guidance on how to comply with the prohibition and notification requirements for scheduled carcinogenic substances. It also explains the specific requirements for assessment and control of risks arising from work with scheduled carcinogenic substances, and the specific requirements for record keeping.
WorkSafe
Code of practice
21 May 2014

Pages