Publications

Showing 76 - 100 of 121 results
Guidelines for the storage of LP gas cylinders on properties in bushfire prone areas.
EnergySafety
Brochure
20 May 2014
Serious incidents have occurred while workers have been carrying out vegetation control work.
EnergySafety
Brochure
20 May 2014
The purpose of this document is to clarify the responsibilities for controlling and clearing vegetation around overhead power lines.
EnergySafety
Guide / handbook
20 May 2014
When was the last time you checked your LP gas installation? Follow this simple checklist to see if your marine craft is safe and complies with the regulations.
EnergySafety
Brochure
20 May 2014
This application form is for an electrician's licence on completion of the Australian Minimum Context Training Program (gap training), which resulted in the issue of a Certificate III in Electrotechnology Electrician.
EnergySafety
Form – application
20 May 2014
This application form is where the existing legal entity has not changed and the trading name has changed or, the existing legal entity has changed its name and is maintaining the same Australian Company Number (ACN).
EnergySafety
Form – application
20 May 2014
This application form is used where the existing legal entity has not changed and the trading name has changed, or the existing legal entity has changed its name and is maintaining the same Australian Company Number (ACN).
EnergySafety
Form – application
20 May 2014
A bush fire occurred near Brindle Road, Parkerville on 3 January 2008 and the Fire and Emergency Service Authority (FESA) advised Energy Safety at approximately 1700 hours on the same day.
EnergySafety
Reports
20 May 2014
Investigation into the cause of the fire determined that it originated when power lines were able to clash during strong gusty winds.
EnergySafety
Reports
20 May 2014
Investigation into the fire at Location 1478 near Esperance determined that it was caused when a Western Power (the network operator) power pole broke and fell over during high winds.
EnergySafety
Reports
20 May 2014
Investigation into the cause of the fire near Katanning determined that the cause of the fire was a fault on a Western Power (the network operator) overhead power line.
EnergySafety
Reports
20 May 2014
Investigation into the cause of the wild fire in Bridgetown determined that the cause of the fire was a fault on a Western Power (the network operator) overhead power line.
EnergySafety
Reports
20 May 2014
Investigation into the cause of the fire in Tenterden determined that the cause of the fire was a fault or failure of a Western Power (the network operator) overhead power line.
EnergySafety
Reports
20 May 2014
Investigation into the cause of the fire in Gingin determined that the cause of the fire was a fault on a Western Power (the network operator) overhead power line.
EnergySafety
Reports
20 May 2014
This form is used to notify Energy Safety of a lost or stolen electrical worker's licence, permit or certificate of registration and to apply for a replacement.
EnergySafety
Form – application
20 May 2014
Generic or global variation or exemptions for domestic or commercial or mobile engine installations.
EnergySafety
Register
20 May 2014
Information about using electricity safely near water.
EnergySafety
Brochure
13 May 2014
A report into the wild fire that occurred at Location 745 Bates Road, Dalyup, about 20 km west of Esperance, on Thursday 2 December 2005.
EnergySafety
Reports
12 May 2014
This application form is for an electrician's licence or electrician's licence endorsed 'electrical fitting work only' for interstate or New Zealand applicants under mutual recognition.
EnergySafety
Form – application
05 May 2014
This application form is to be used by a person holding an electrician's licence endorsed 'electrical fitting work only,' wishing to upgrade to a full electrician's licence.
EnergySafety
Form – application
05 May 2014
This application form is for an electrical worker's electrician's provisional Licence to work under supervision.
EnergySafety
Form – application
05 May 2014
This application form is used to apply for a ground geophysical survey equipment permit.
EnergySafety
Form – application
05 May 2014
This application form is used to apply for a restricted electrical worker's licence for interstate or New Zealand applicants under mutual recognition.
EnergySafety
Form – application
05 May 2014
This application form is used to apply for a refrigeration and airconditioning mechanics licence where the qualifications were gained overseas.
EnergySafety
Form – application
05 May 2014
This application form is used to apply for a mobile mining permit.
EnergySafety
Form – application
05 May 2014

Pages